How To Find The Gear Ratio Of A Rear End - How To Find
Rear end gears Chevy Truck Forum GM Truck Club
How To Find The Gear Ratio Of A Rear End - How To Find. Figuring rearend gear ratio (ring & pinion) formula: Our experts will help you find the correct ring and pinion set for your particular application.
Rear end gears Chevy Truck Forum GM Truck Club
You could count the number of teeth on the ring gear and then divide that number by the number of teeth on the pinion gear. Divide the number of teeth on the ring gear by the number of teeth on the pinion in order to. If the vehicle was purchased secondhand, this tag may not be valid if the previous owner has changed the ratio,. This tag, which is always present (if not removed by a previous owner), will indicate the gear ratio that came with the vehicle originally. To do another, enter a new set of values. We have a large selection of gear sets in stock and can recommend the correct gear ratio to match your engine horsepower,. The tsm has the reference chart. The value will be returned in estimated differential gear ratio, based on the entered values. In the above example, 37 ÷ 12 = 3.083333. 2 ¾ rotations = 2.73 gears
With the transmission in neutral, rotate the rear driveshaft by hand. If the vehicle was purchased secondhand, this tag may not be valid if the previous owner has changed the ratio,. 2 ¾ rotations = 2.73 gears If it's a little more than 3, you have 3.08s. Vin code, dividing the ring and pinion teeth count, and counting the wheel turns. If this tag is gone, as they usually are, put the rear end up on jack stands, mark a rear wheel, mark the drive shaft, and count the drive shaft revolutions to each wheel. To verify, or to see if that ratio has changed, you can jack up the rear axle and support it with jack stands. The tsm has the reference chart. 7.5 inch, 8.5 inch, 10.5 inch. You could count the number of teeth on the ring gear and then divide that number by the number of teeth on the pinion gear. This mark is made to identify where the center is, or the count/start point so we can count the.
